NHT SA-2 Manual de usuario descargar pdf (Pagina 10)

This method of connection is recommended if you have a receiver with no line level preamplifier output of any

sort and you want your L & R speakers to receive a high-pass filtered signal. The SA-2 may be connected to

the system at speaker level between the receiver and the speakers. The SA-2’s speaker-level output has a

fixed 100Hz high-pass filter that removes frequencies below 100Hz before sending the signal on to the speak-

ers. The speaker-level high-pass filter is not adjustable. This method is not recommended if the L & R speak-

ers are large, full range models.

1) Connect a pair of speaker cables from your receiver’s front L & R speaker output terminals to the SA-2’s

INPUT FROM AMPLIFIER barrier strip.

2) Connect a second pair of speaker cables from the SA-2’s OUTPUT TO SATELLITES barrier strip to the front

L & R speakers.

3) Connect the SA-2’s SUBWOOFER OUTPUT to the SW2Si input terminals with speaker cable.

Connect the SA-2 at speaker level from the receiver’s speaker outputs,

with fixed high-pass filter

Use if:

You wish to send your L & R speakers a high-pass filtered signal

Your receiver has no “Pre-Out”, “Line Out” or “Subwoofer Out” jacks

SW2Pi Connection Method #3

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Sin comentarios

NHT SA-2 Manual de usuario Pagina 10